KLM (:math:`K_{L}^0` and Muon Detector) ======================================= In the following we describe the ``klm`` package (documentation still under development). Modules ------- This is a list of the ``klm`` modules. Some modules (in the ``klm/bklm`` and ``klm/eklm`` subfolders) that are currently used only for debugging or specific studies are omitted here. .. b2-modules:: :package: klm :regex-filter: ^KLM :io-plots: .. b2-modules:: :modules: MCMatcherKLMClusters :io-plots: Clusterization -------------- Few words about how a ``KLMCluster`` is built starting from ``KLMHit2d`` are more than desirable. Muon identification ------------------- .. toctree:: MuonIdentification Calibration ----------- .. toctree:: Calibration Tools ----- ``b2klm-create-dqm``: Create DQM reference plots ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ .. argparse:: :filename: klm/tools/b2klm-create-dqm :func: arg_parser :prog: b2klm-create-dqm :nodefault: ``b2klm-mask-dqm``: Mask very hot channels in DQM reference plots ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ .. argparse:: :filename: klm/tools/b2klm-mask-dqm :func: arg_parser :prog: b2klm-mask-dqm :nodefault: Disclaimers for development ---------------------------- Charge or Pulse Height from Feature Extraction: * Due to (scintillator) firmware anamolies, there are peaks near 0 and :math:`> 400` ADC counts; these values are unreliable. * The performance with and without the cuts should be evaluated before suppressing these peaks or replacing them with NaNs. * The peaks at charge :math:`> 400` ADC counts have been a result overlapping ramps negatively shifting the output voltages (lower Wilkinson ADC counts). * The KLM firmware was updated on Exp 40 Run 858 to properly address this bug. * Details are outlined `here `.